Posts

Chosen Solution My gas dryer drum suddenly stopped working in the middle of a cycle. The drum belt had actually snapped. I replaced the belt, everything is working, but now it won’t heat up. I find it hard to believe 2 different parts went out at same time. I checked all wires and nothing is loose. Also, there are no blockages from lint, etc. Not sure if heat source gets tripped when drum stops working or if there is some type of reset?...

Chosen Solution I don’t know why this happened but I was just on my phone and it was working perfectly fine, then I pressed the home button like I always do and it just started rapidly clicking even though I only clicked it once. I did not have a screen replacement, I tried restarting my phone but it did nothing. It could be screws loose or something, but it was working perfectly fine all day until now....

Chosen Solution Hi, I always put my iMac on sleep when i am not using it once a time when the iMac was on sleep I heard a strange noise like (zeeee,zeeee,zeeee,zzzzz) it’s like it want to run or do something and it can’t the after half Minutes shows a question mark inside a file Sounds like your hard drive has failed. Start up from your system installation disk by inserting the disk and starting holding down the “c” key....

Chosen Solution Hi, I recently replaced my note 8 screen by following ifixit guide and it works fine. However the phone now heats up even if its not on charge. Can you please advise on what might possibly be the problem? Damaged battery or something else? You’ll have to figure out yourself since you’re the only one who can find out what’s the part that warms up first and most. You might need to probably open up the phone again....

Chosen Solution I recently tried changing my sander paper on my sander pad however the sand paper is no longer sticking. I had left the sander in the garage and it may have gotten a little wet, what do I do to be able to fix this? Hi @jpiazza. I am a woodworker number it sounds like you need a new sanding pad or bring the sander inside your house for a day to let it dry out and that goes same for the sand paper since it’s hook and loop....

Chosen Solution My remote was working fine then one day it just stopped. I’ve changed the batteries in my remote and even tried universal remotes. Nothing works and I don’t know what else to do. Hi @bunnzike , Have you ensured that the remote control receiver window in the TV is not being blocked by anything, preventing the signal from the remote control being received? (click on image to enlarge for better viewing)....

Chosen Solution The shutter is stuck and won’t respond. Make sure the lens is clean and nothing obstructs the shutter’s path. Use either microfiber or tissue and cleaner to carefully remove any debris, use compressed air around the lens and shutter area. Also check out the troubleshooting page if you have any further questions. Nikon Coolpix L840 Troubleshooting Also check out the troubleshooting page if you have any further questions. https://www....

Chosen Solution My phone does not ring, it just vibrates. Update (01/07/2016) I have tried all of the suggestions, none worked. Tech at Metro says that a Dolby Digital Plus may have been activated which he couldn’t delete the app. Hi, Have you checked the following Touch the Home Key > Menu Key > System settings > Sound. Touch Phone ringtone Scroll through the ringtone list and select the ringtone you want to use....

Chosen Solution I brought a huawei honor 8 lite, and it’s screen is keep turning off and after a while it stops doing it. Hi, Have you checked the “sleep” setting in the phone to make sure that it is set to what you want? Go to Settings > Display > Sleep. Try disabling the Automatic screen lock feature and check if this resolves the problem

Chosen Solution I dropped my phone and it broke the display. I replaced the LCD and it is now working fine, except for the battery is constantly reading 100% but the phone dies very shortly after being unplugged from a charging source. I have cycled the battery and reset the phone completely, is there a chance something on the charging port is causing this, or will this end up being a logic board problem?...

Chosen Solution I just bought a used battery for my wife’s MacBook. Her battery had 450 cycles or so. Now I know I am taking my chances on a used battery from eBay, but the seller deduced that this battery has less than 100 cycles. He explains that it came out of a broken computer and is ‘good as new.’ I plugged it in cold to her computer today and the cycle count was 732!...

Chosen Solution Hi guys! I’m looking for an aluminum capacitor to replace C9560 on a 820-2850-a motherboard and looking on internet, I foun this: https://industrial.panasonic.com/ww/prod… Will this work? And another question, when looking for an smd component, are the specs on the schematics all I need when shopping for components? For example, if I’m looking for a capacitor and the schematics indicates voltage, % and capacitance, am I completely safe if using a capacitor that matches this specs only?...

Chosen Solution Will it support a 1TB hard drive? Yes, this laptop does support a 1 TB drive. Dell Inspiron 1545 Hard Drive Replacement Crucial MX500 1 TB SSD 1 TB SSD Hybrid 2.5" Hard Drive

Chosen Solution After replacing the screen assembly and lightning connector assembly the phone wont charge and home button feedback does not work. Otherwise phone seems to work OK. I checked all the main connections,but the problem remains. Any suggestions? Thanks! It sounds to me that the replacement part you have is faulty. Have you also checked to see if the speaker is working? If not then its definitely defective as all those components run off the charge flex....

Chosen Solution My Microphone does not work in speakerphone mode. Can anyone tell me if the microphone is included in the following replacement assembly. Phone 5 Front-Facing Camera and Sensor Cable Replacement Thanks, AH. the phone has 3 mic’s. one main at the bottom, 2nd next to the back camera and 3th is on front next to the ear speaker. i think the 3th one is used for FaceTime and causes your problem....

Chosen Solution Hi Everyone, So I was shooting on a tripod this afternoon when I suddenly tripped on said tripod. It fell on the floor with the flash mounted to top of the camera. The top part of the flash detached leaving the base mount stuck in the camera. Only 3 wires out of 5 remained soldered. I had to force-remove the remaining wires in order to be able to detach the mount from the camera....

Chosen Solution Hello everyone. I’m having trouble with an iPhone XR. The issue is I downloaded the newest software and let the phone go through its paces and it all went just fine until it came down to the stage of installing the software. When it’s ready for installation the Apple logo shows up with the line underneath and the bar starts to move. Before the bar even gets to the Apple logo the phone shuts down then turns back on after a few seconds then repeats the process over and over again until I disconnect the battery....

Chosen Solution Recently I sent my iPad to be fixed for broken screen (the LCD was intact), they separate the digitizer from the lcd and put a new digitizer on and keep the original lcd. They did a good job fixing it, but after a day it began to have a distorted screen when I wake up the iPad. It goes away and function normally after a couples of seconds and sometimes for longer....

Chosen Solution My water cooler was working and all of a sudden the water is not cold. What do i do? Check the plug & outlet and the fuse/breaker. Is the unit getting power? If the unit is getting power then the compressor is not working correctly. It could be out of Freon or the compressor its self is shot. Which is why you aren’t getting cold water. If you are getting cold water not hot then the heater unit is burnt....

Chosen Solution My family has had a Kenmore Elite freezer (model # 253.28092803) for a little over five years. It has stopped running, but the lights are on inside. The display shows 0- instead of 0 F. The buttons on the display aren’t working, they just beep when you push them. How do we get this fixed? Cause 1 Condenser Coils are Dirty If the condenser coils are located within the freezer walls, the coils do not require cleaning....