Posts

Chosen Solution I have a 2000 Jeep Cherokee 4.0L ( XJ ) limited trim. It will not idle correctly. below the regular RPM or above….. i replaced the idle position sensor and had the IAC system reset by a friend who is a mechanic. ( idle sensor was to blame, to keep my question short). Everything seemed to be quite fine having done this yesterday. Even seemed to run better/stronger. Until this mourning when it would not idle at all…....

Chosen Solution I replaced the battery in my ipod touch which didnt work at all before now it will turn on to the apple screen but stays there what should i do? DFU mode = Device Firmware Update mode To go into DFU mode: Open iTunes, plug iPod into computer. Hold down Home button and Power button simultaneously until the device goes black Let go of Power button, but keep holding down Home button After 10 or 20 seconds, you should hear a beep, and now iTunes should recognize it in DFU mode....

Chosen Solution Hi guys hope you can help me out here. The mains adaptor has stopped working as I can see a wire has come out near the connector plug due to wear and tear. I am having difficulty locating a replacement mains adaptor as the last adaptor I purchased just didn’t work. I think the issue is that the keyboard is a good 15 years old and the original adaptor is no longer available....

Chosen Solution Hi, When someone is calling me, it’s difficult to hear him. The volume is max (using the buttons) but the sond is very low … Is there an issue ? Best regards PS : Iphone 4S on IOS7 Update (01/06/2014) No Clue/Idea ? Usually a replacement sorts it out not sure on this 1

Chosen Solution I have a ZT (Zero Tolerance) model 0808 folding pocketknife that has a stripped TORX head screw (originally T-6 bit), one of four that’s used to hold the metal grip panels onto its internal frame structure. The screw is extremely small (thread size unknown; ZT so far won’t tell me that info), and is set into a countersunk pocket in the grip. This pocket makes cutting a slot using a rotary tool and cutting bit like a Dremel impossible, at least without damaging the grip panels of the knife at the same time....

Chosen Solution I have a Samsung French door fridge model RF25HMEDBSG/AA The interior lights usually come in when either door is opened. Today the lights stopped coming on when opening the right door. The lights come on when the left door is open. I have tried all combinations of opening the doors in different order. It doesn’t make a difference. It used to work and now doesn’t. Since the lights all come on when the left door is open I’m guessing there is some sensor somewhere on the right door that is malfunctioning....

Chosen Solution So I accidentally dropped my ipod nano 4th gen in clean water but it only stayed there for about just 2 seconds because I quickly grabbed it back, it went for just about 1 feet under. I turned it off before putting it in a bag of rice. After 3 hours, I hastily grabbed my ipod back and I turned it on, it works fine, the screen is perfect, it can play songs, I could still connect it to computer… But the problem is everytime I turn it off, it turns on by itself after 1-3mins....

Chosen Solution Hi My Asus Laptop recently started to crash randomly, its not an old laptop, It can go anywhere from a few days to a few seconds and crash. It sometimes boots into bios, and sometimes boots into windows 10. I ran malware bytes and came back with nothing, ccleaner, cleaned the registry, temp files, disk cleanup, defrag, just got done doing a reset and its still crashing. Any help would be appreciate....

Chosen Solution WHY my iPhone 4 is cracked and I tried cleaning out the USB I didn’t see any dirt and tried cleaning out the earphone and I’m just true of using earphones what do I need to do Regardless of how this happened. You need a new speaker box. Here’s one. They’re relatively simple to install iPhone 4 Speaker Enclosure Replacement [linked product missing or disabled: IF182-013-1] Hi there, You may need to replace your charging port or speaker....

Chosen Solution I’m having problems with my Mid 2010 15” MacBook Pro 2.66 GHz i7. I recently purchased a Crucial MX500 SSD SATA 6Gb/s 2.5” SSD to replace the old HDD. When I reboot the laptop up, it won’t recognize the new drive. I was told this SSD type would work, was this wrong? If so, what type of SSD should I get? Is it not working because it’s 6 Gb/s?...

Chosen Solution I followed the steps for battery replacement and was able to remove the battery. I place the new battery in and began to screw it in. I was able to screw one in (5.2 mm), but when I attempted the next one (13 mm) there was no entrance to screw in. Why can’t I screw this in? Why is this battery different? Is it better or did I get the wrong type of battery?...

Chosen Solution My laptop will not come on with an adapter or batteries. I have a Dell Inspiron N7010 Laptop Did you ever change the battery? These are from 2010 just based on the 1st generation Core i processor - unless the battery was replaced recently, they’re pretty much all dead outside of the well maintained packs and even those are done after 5-6 years as everyday batteries. BUT before you go out and buy a new battery, try booting without one installed and see if it powers on....

Chosen Solution hi i bought a 1tb hard drive for my mac 1tb Western Digital 5400rpm 2.5 7mm but it doesnt get recognized by the mac, i swap it again to the old hard drive and works fine, its not the flex cable i was wondering if theres some sort of compatibility with some hard drives Actually I found that YouTube video it’s showed me it was the motherboard I don’t have the video right now but explain it very well my issue...

Chosen Solution Why won’t my phone turning on? Try plugging in your phone for about half an hour to see if it will charge. If it isn’t charging, your charger might be broken, or the charging port may be dirty. If neither of these issues are the case, your the cable connecting the power button to the motherboard may be broken and need to be replaced. You can read more about these issues and their solutions on the BLU Studio 7....

Chosen Solution Speaker will play for a few seconds then goes silent. Fully charged and has been factory reset numerous times. llopez478 could be an issue with the amplifier IC or the Bluetooth receiver. You may have to disassemble itand check for any obvious damage on your boards. Post some images of your boards so we can see what you see. Use this guide Adding images to an existing question for that

Chosen Solution New battery. Cranks about 1/2 turn and that’s it. Battery is fully charged. Could it be my compression? craftsman lt2500 model 247.289150 @mikeyg , Mike, It is totally possible for your lawn tractor to not turn over because of a compression issue. Pull the plug/s out and see if the engine spins good and freely(see 1st link below), if it does then a valve adjustment is most likely the remedy....

Chosen Solution I have an SD card inserted in my phone, and my internal memory is full, but all my apps are already moved to my SD card except the ones that come with the phone, which, dont have the option to move the the SD card, so since the internal memory is full it wont let me download apps even though i have an SD card inserted. Hi, If your phone is installed with Android Marshmallow 6....

Chosen Solution my phone wont turn on never been dropped or wet got it new in box 6 day ago made 2 phone calls and 4 texts and then it died and never came back on again i have tried every thing what can i do Hi k1d0, If you have tried the following: Removing, reinstalling the battery and then trying to start it. Trying to start it with the charger connected and switched on....

Chosen Solution Its on 70% charge but will not charge further. Tried different chargers and turning on/off Hi, What happens if you use it until it only has about 10% -15% charge left? Does it charge past 70% when you go to charge it? If not, if it is an original battery perhaps it’s starting to fail. Even rechargeable batteries have a lifespan. Here’s a link to the ifixit Bose SoundLink Mini Battery Replacement guide....

Chosen Solution Bought a battery from ifixit.com and changed it following the guide. Now the phone turns on but the volume when making a call is really low. How do I fix this? The volume when the ringtone for incoming call is normal. Regards, Tobi The battery change wouldn’t affect the earspeaker. Remove the LCD and check if the components are placed right,