Posts

Chosen Solution My MacBook fan makes so much noise when I use an application I have downloaded a fan control app but that doesn’t seem to work. I need help! I wouldn’t be surprised if after these many years air intake would be difficult because of dust accumulated. If it was never serviced before a good internal cleanup and thermal paste replacement might do wonders ;) Edit by mayer Remove the fan and clean out the vent, here’s how: MacBook Pro 13" Unibody Late 2011 Fan Replacement Also, this model has a liquid filled heat sink that can develop a leak....

Chosen Solution My battery seems to run out very quickly after being fully charges. The battery is most likely to be faulty or the charger is also faulty. Is quite normal. All the batteries decrease performance after every “cycle”. Try to see how many life cycle your battery has.

Chosen Solution I want to know what is the problem with my iPhone. When ever I try to power on my iPhone it shows apple logo and goes off! I tried connecting it to my laptop for recovery my iTunes shows that your phone is off! I don’t know what is the deal with it? Please help me out! Start by doing a hard reset. Hold home and power until the Apple logo appears....

Chosen Solution I was using my iPhone normally to watch Netflix yesterday, and as soon as the battery was starting to die, I plugged in the iPhone to the charger. I soon found out that my iPhone wasn’t charging anymore. In order to diagnose it, I started with the basic and that was to see if it was my wall charger or my cable that was causing the problem or not....

Chosen Solution microphone is not working.. whenever chatting I can hear friends but they are unable to hear me Hi, Try using the earphones with the microphone attachment. If you cannot be heard on a call when using this, there is a problem with the voice transmission circuitry on the mainboard in the phone. If you can be heard when using this then your problem is either a faulty or loose microphone in the phone or perhaps the voice inlet hole located on the bottom edge of the phone may be blocked by dust or lint....

Chosen Solution Installed new battery ,restarted and only charged 16% overnight . What could be the cause? Hi Charles, I also had a sort kind of issue like this. I was required to disassembly my phone again, disconnected the battery and screen, after this, reconnected it again and tested it while the phone was still open, suddenly it worked. Assembled it again and everything was fine afterwards. But it’s still possible that you have a bad battery again....

Chosen Solution Whenever I try to make a call or send a text message, my phone says “No SIM card is detected”, but the SIM card is installed. Why? This might be a problem with the SIM card itself. In order to fix this problem, the SIM card will have to be replaced. If replacing the SIM card is still not working, then it is most likely the problem is within the motherboard....

Chosen Solution Hi All, I’m having a problem with my Samsung Chef Collection Refrigerator (RF34H9960S4AA), which When I select a type of ice on the outer control panel (top left door), it will begin to beep and the display with flash after a few seconds. This has nothing to do with the inner temperature (which remains at 37 degrees F) as the beeping happens even with the door closed. Also, when I try to reset the filter (bottom right door, inner control panel) a ER PC shows up on my screen....

Chosen Solution Thank you for your time, I bought an un used ti-92 plus. The cursor pad requires significant force for down and left, but nicely clicks for up and right. Any help from your experience is very helpful. Thank you for your time, Erik The conductive “paws” on the silicone button membrane where not landing flat onto the logic “prints” on the circuitboard. This is do the design of the D-pad button....

Chosen Solution I have a second hand Samsung TV model no:UN43NU6950FXZA that may have experienced a power surge with it’s previous owner. It had no standby power light(the red LED) and naturally would not turn on when the power button was pressed, nor by remote control. I have tried plugging it into different outlets and surge protectors(all working) as well as holding the power for 30 seconds while plugged in/unplugged to reset it....

Chosen Solution i bought a broken imac from 2007 and when i turned it on it make 9 beeps when i opened it i realized that only three leds were lit except the led on the LCD how can i fix this problem? 1 beep = no RAM installed 2 beeps = incompatible RAM types 3 beeps = no good banks 4 beeps = no good boot images in the boot ROM (and/or bad sys config block) 5 beeps = processor is not usable....

Chosen Solution Every time I try to eject the disk from the drive, the tray fails to eject. When I press the eject button a motor sound is heard, but the tray fails to open. There may be a disk jammed in the device. You can try and manually open the drive but be careful as the tray may break. Or you might have to take apart the device and replace the disk tray belt....

Chosen Solution I just replaced the motherboard in my Mid 2009 13” unibody macbook pro. It all seemed to go very well, then I turned it on. The machine powers up but all i get is a white screen. No boot. Any ideas on what may be the cause? Other than review your connections I would say the logic board you got is bad. You’ll need to return it to get either a replacement or your money back....

Chosen Solution I can’t. Get my vacuum roller to engage when I step on the lever that makes the roller spin Remove the roller and look for any anomalies. Eureka AirSpeed Bagless Zuum Brush Roll Replacement

Chosen Solution So my tv worked with the PS4 for quite a while, up until a few months ago, when my boyfriend let his parents borrow it. He had gone over to use it, and when he turned it on the screen wouldn’t give a clear picture, and it was giving off a clicking sound. We’ve tried two different HDMI cords, and plugged them into different HDMI ports, but all met with the same result....

Chosen Solution I am switching the remote control to the on position but the light is not illuminated. The remote control most likely has a dead battery. To replace the battery, slide open the lid at the bottom of the remote control and take out the 9V battery. If you have a voltage meter, test the battery to ensure it is dead. If the tester reads less than 7.5 V, it won’t be able to power the remote....

Chosen Solution My phone died after I had recharged it. I attempted to do a restore through iTunes which looked like it had been successful, everything had been restored, updated from a previous backup. However, when I turned the phone off and later tried to turn it back on, I got the apple symbol but then nothing! I tried the restore process again which just repeated the outcome stated above; does anyone know how I should proceed, if I can at all, please?...

Chosen Solution It is currently out of stock, but the display by itself is still in stock.Google Pixel 4a 5G Screen - Genuine this is not the store its only a help forum, contact ifixit directly

Chosen Solution Hello! I am also having the same problem. I did what u suggested and nothing. I opened the computer and I noticed that 1 of the plugs P5 was not connected to anything. My question is should that part be connected and if so where? Maybe that is what is causing my G3 not to power up? Thank you. Edie The Plug “P5” is just another 4-Pin Molex power connector....

Chosen Solution Hello Dear, My pc has taken a hard shock, by falling under the table. after, he shut down. And wont boot up, by showing a message : that he doesn’t find any exploitation system to boot up with. i tried too many time to format it but with no answer. it shows blue death screen after the format ends. after that he stops even completing this format and shows : Error 0x8004245F And for the temperature its always high....