Posts

Chosen Solution I’ve re-heated the Graphics and the Processor and the four small chips. I’ve done that three times thinking I’m not doing it right but no luck. Could it be my disc drive? My disc drive cable is a little damaged from the previous owner but its not badly damaged to the not working point. Hi! The Optical drive in a PlayStation can’t cause a YLOD. If you tried everything mentioned in those guides and it still isn’t fixed, you’re out of luck....

Chosen Solution I have a GE 2004 Microwave Profile series MODEL NO. SCA1001HSS 01 LOUISVILLE, KY. 40225 www.GEAppliances.com MADE IN KOREA SERIAL NO. GG 902793K And it stopped microwaving no heat just a loud buzz and sounds like it’s working but no heat? Any reset options before I throw it in the dump? Hi, Check that the two door switches are operating OK and that they’re not loose, faulty or perhaps the door actuating latch is not operating them fully etc....

Chosen Solution my machine started with this issue today, or at least i noticed it today. everything on the machine seems to be working fine, except the agitator. it will even agitate without any issue for a minute or two after I unplug and then plug in the machine, then it just stops agitating. there is no noise either, so it seems to be different than what generally causes issues with the agitator....

Chosen Solution I was on my phone then switched the power button off, when I turned it back on again the screen had lines on it (red lines) and went crazy, all of a sudden it came back on but it was clicking on things I hadn’t, then it just went back to having the red lines on it, I don’t know what to do! You probably have a damaged/defective screen....

Chosen Solution So i bought a iPhone 11 on Offer-up, said it was in restore mode and they didn’t have a pc to plug it in. Decided to buy it because it seemed like a simple fix, but turns out i’m wrong. I keep getting the same error, 4013, in iTunes. I Updated iTunes and my windows pc and tried every port on my pc that I could. I did some research and found out that i may possibly be a proximity sensor issue where some water gets into it, but im hoping that its now....

Chosen Solution ipod classic only lasting 20 min when fully charged Its Time To Change The Battery …. Hope It Works Thanks Varun this sounds like you may need a new battery. no matter how good of a battery you have eventually if you use the device you will need a new one. battery have an finite amount of charges before alas even they die. the way you can tell if your battery is dying a lot of the time is if it no longer holds a charge for very long....

Chosen Solution My laptop seems to heat up very quickly while I use it and it eventually shuts off. After waiting for a bit and turning my laptop on it repeats the same thing. Your fan may be failing. I would listen to see if you can hear the fan running when the computer is performing a task. If the fan is silent, it may need replacement. Try following this guide: Acer Aspire 5742 Cooling Fan Replacement...

Chosen Solution my phone was displaying a loading sign as if it was dying for an hour then i force restarted it (held home and power button for 30 seconds) and it worked to get me off that screen , but now my screen is white with the black apple logo and its been an hour and not turning back on. its stuck on that screen and wont go off ....

Chosen Solution Whenever I go to click my phone’s screen it seems unresponsive at first but then is just taking a long time to register my input. Hey Andrew, One reason why you’re touchscreen is slow may simply because your screen is dirty. If this is not the case, it may be a circuitry failure. Try rebooting your phone by turning your phone off for 20-30 seconds and then turn it back on....

Chosen Solution I recently replaced the screen on my wife’s watch and figured I should replace the battery since it was open. The screen replacement went great but the battery I bought from ifixit seems terrible. Are the batteries sold, used or new? I have a series 1 Apple Watch that has its original battery and its life is still way longer than the series 2 replacement battery. I unpaired and set up the Apple Watch as a new watch and updated the software....

Chosen Solution I replaced the battery in my MacBook Pro 13” Touch Bar Late 2016 using the iFixit battery replacement kit. After the battery was replaced, the right fan started running at full speed (approx. 8600 rpm). I rechecked all of the connections inside the computer including the touch bar connection as suggested, and the fan still continues to run. I downloaded two different fan control software applications, and am unable to control the fan speed....

Chosen Solution The computer turns on, but for some reason I can’t hear anything. Hi Aaron, Your speakers might be muted. To turn the audio back on, find the speaker icon in the bottom right corner on the taskbar. If it’s muted, there will be an (x) next to the speaker. Click it to unmute.

Chosen Solution i have 2 iphone 4. one is locked to some network and second I bought cheap because it have broken screen. i test it both and both of them charged very fast. than I put logic board from broken iphone to locked and than i normally turn on iphone and everything works normally but when i connect charger cames icon for charging but batery pecentage became lower and lower....

Chosen Solution It was working but suddenly ot is not starting and i can’t connect to my computer also please help me Try connecting your charger then holding down the power button for 20 seconds then disconnect the charger and hold the power button for 20 seconds again . then release and try to boot normally. If this cycle brings no joy open the tablet and disconnect the battery. It will involve a soldering iron but if you disconnect for a few minutes it will clear the memory and let you have a clean boot which should allow the tablet to boot....

Chosen Solution I have just received an iHome model iBT73. I can turn it on, and the lights will blink and flash, but that’s all it does. When I plug it into my phone or computer to play music, I will press play on my device but it won’t play anything through the speakers on the iHome. I can turn bluetooth on on both the iHome and my phone, but my phone won’t find it....

Chosen Solution My fire stick notified me that my batteries were going low so I changed them and now my remote won’t turn on at all…this is the second time this has happened to me. What do I do? Hi I own 5 fire sticks and once in a while this happens to me as well. I do not why but you must use fresh new batteries for the pairing to be successful ....

Chosen Solution I go to play store and try to update apps and it says cant be downloaded or something about the server . its really aggravating me because i just got it for Christmas and cant even use it !! Hi, Check to see if the Download Manager App is enabled. Not sure where it is in your phone but usually you find it in Menu > Settings > Apps Swipe to ALL APPS....

Chosen Solution I press the power button and nothing….the iMac just wont turn on, it does receives power because I connect an external hard drive and I can see the external drive comes on…..now Im not much of an electrician, but Im not sure if that means the power supply is working….if the external drive comes on, but the iMac doesnt even makes a sound, it just stays off….I have however tried it on different wall outlets and samething, it just wont come on…I tried connecting it to a Mac mini and started on firewire mode, but it didnt come on, I believe its the power supply, but whats with the external drive coming on when I connect it to the iMac…i dont hear no fan, no nothing, any suggestions or advice would be greatly appreciated, thanks!...

Chosen Solution i have had the Polaroid snap for about a year now and i went to use it one day like any other, took a photo like normal and it responded fine but printed a plain sheet with no photo on. i have waited hours in case it was going to develop but nothing, the paper isn’t jammed and the camera itself is responding fine up until the photo prints....

Chosen Solution Hi, I’m planning on purchasing the 2020 Mac mini in the next couple of weeks. It makes much more sense to upgrade the RAM by myself, but I want to make sure that using the 2018 RAM upgrade guide will yield the same results for the 2020 machine. Any guidance would be super helpful. Thanks. Sadly, Apple doesn’t offer details for the RAM in the 2018 or newer 2020 Mac mini’s in their RAM guide Upgrade or install memory in your Mac mini Which is technically WRONG!...