Posts

Chosen Solution washer maytag model MAV 7258 AWW DOESN’T GO INTO RINSE CYLCE ALL THE TIME? Cause 1 Lid Switch Assembly The lid switch assembly prevents the washer from spinning when the lid is open. If the lid switch assembly fails, the washer may stop mid-cycle. To determine if the lid switch assembly is defective, use a multimeter to test each of the lid switches for continuity. If a lid switch does not have continuity, replace it....

Chosen Solution when I push power unit just keeps clicking nothing else happens, no picture or anything. Iread some where that may be fuse steve beseke, start with the basic major checkpoints. This is still one of the models that may suffer from Samsungs decision to use substandard capacitors on the power board. Your symptoms are pretty indicative of that. Post some good images of your power board etc. with your question....

Chosen Solution my iphone 4 was working perfect yestarday morning. i charged it and it was fine. then later on at night i run out of battery and when i got home and try to charge it again. nothing happened Battery is bad. Charger is bad. USB cable is bad. Clean iPhone dock port with a clean dry toothbrush. Try to charge. If nothing, clean dock port with a bit of Isopropyll Alcohol, either using toothbrush again, or with lint free cloth....

Chosen Solution I’m having issues with my iPhone 6. I’m relatively tech savvy so I’ve tried to trouble shoot this as best as I could. I went through all the standard network setting resets and restores with no effect. Here’s what’s happening: The wifi signal is often weak but it’s worse than that. The phone will constantly drop and reconnect to networks as well as cycle through different signal strengths. Other times no networks will appear at all and when my network finally reappears it won’t be able to connect....

Chosen Solution I successfully fixed the screen on my old Samsung Galaxy S4, but there is another problem. I’ve circled in red which small golden connector has been broken, is there any way to fix this connector or somehow get a replacement for it? It’s made the WiFi signal become extremely low unless I put pressure on it with my thumb, that is the only way the Wifi signal comes back....

Chosen Solution Mower will not start except when I jump solenoid. Jump black spade terminal on solenoid to negative battery terminal, the engine starts fine using ignition key. Also, lights and hourmeter do not work when running. Lights do work when connected to 12v direct and the light circut at the pull-apart connector is getting 12v when grounding meter to frame. Thought it was ignition switch and bought new one but same problem....

Chosen Solution My Google Nest Audio stopped working after connecting the charger to 220 V in Europe. I could hear the “spark”. I wonder whether inside the body is a fuse which got busted and then I could try to fix the G. Nest Audio by replacing the fuse. Thank you in advance for advice. Peter. I would of thought the charger would blow before the nest. Try another charger if you can before opening it up....

Chosen Solution I was just browsing on EBay and suddenly my wireless is disappeared and can’t be found in the device manager or in the wireless connections screen… My wireless button is orange and clicking it doesn’t change it, all it does is put it to airplane mode. It’s not a Wi-Fi issue because I can connect in my other laptop and on my phone. All that is showing in the Network Adapter of my Device Manager is ethernet (which works perfectly fine but I’d love to have my Wi-Fi back D: ), nothing that says Wireless, it legitimately was as if it never existed....

Chosen Solution I found this super tiny spring in my disk drive while repairing my ps4 slim. Please tell me where to fix it. it sounds like it would have come off where the laser meets the motor in the drive.

Chosen Solution When changing the desktop background, I get a continuous rotating coloured ball and no further reaction. This is probably a software problem. You could contact Apple. First though try quitting out all of the other running programs and setting the background. The if that doesn’t work try restarting the computer then setting the background. Then check that the file will open at all (eg go to finder and open the file)....

Chosen Solution I have an iPhone 6S that will not receive touch out of nowhere. There are no lines on the screen or anything like that. I can be using it and then it would stop. The only way to fix it is by locking then unlocking it. Could it be a software or hardware issue? Probably need to get the screen replaced. Common thing with bad aftermarket screens.

Chosen Solution My unit is not working. Hey Cline, your A/C compressor clutch is supposed to be magnetic when there is power at the clutch coil, this is how the clutch engages the internal components of the compressor with the pulley that is being driven by your serpentine belt. To help you figure out why your A/C isn’t working, with the car running, turn your A/C to Max/Recirculate, and see if you see the clutch on the front of the compressor engage....

Chosen Solution So when i put my charger in my controllers for about a couple minutes/hours . After i unplug my ps4 controller, its dies Sounds familiar. So, if the cable is in, it all works ? And after you plug it out, it dies immediately right ? If yes, you need to replace the battery. Guide how to replace the battery: DualShock 4 CHU-ZCT2U Battery Case Replacement

Chosen Solution My speaker has suddenly began making a single sound every few seconds which sounds like a single busy signal on a phone. I have read the manual, turned off/on both speaker and phone without success. It’s low on battery. Plug it in! Mine just needed to be charged. I think the busy signal tells you it needs a charge. We all get hungry! The best answer I have for you is that your rechargeable battery needs to be replaced inside the unit....

Chosen Solution It is stuck on this screen won’t shut down of this screen I will try to help. Try to open it up take the battery out and re connect it. If that dose not work try to get to the bios setting by clicking the power button and volume button and then go to reset. I am not an android user but I don’t know if it will delete your info if you go into bio settings....

Chosen Solution When I take a picture the built-in flash does not fire. Once no external flash is attached the built-in flash may not fire if the spring or metal switch in the hotshoe( the flash socket) that allows the flash to fire, is stuck. Dirt may be the cause of this. To fix it, clean the hotshoe with a soft brush or compressed air. If it still does not fire, unstick the spring with the help of a probe or pick....

Chosen Solution The Element GC-1020 is a media player, so it has capability to play movies. However, when I go to the video option on the main menu and choose the movie I want to watch, it says “WARNING FILE FORMAT ERROR.” How can I fix this? The Element GC-1020 comes with a mini-disk that you can put in your computer’s CD slot. Insert the disk and install the AVI converter....

Chosen Solution After not using my phone for a couple of hours, I realised it had turned itself of. I figured it might be low battery, so I let it charge, but I still couldn’t turn on my phone. After that, I tried to take out the battery and press the power button for a minute, and then put the battery inside and turn on the phone. When that didn’t work, I tried to boot it in recovery mode by pressing the power button, volume up and home button....

Chosen Solution So I had this tablet laying around the house, and no one was using it because we had lost the charger (and no one wanted to replace it) so I ordered a charger on amazon and I plugged my tablet in and waited for about 20 min before trying to turn it on. It isn’t working. I do not think it has anything to do with the charger. Anyway, I would be really grateful if someone can tell me what to do!...

Chosen Solution I have a wine damaged MBA mid 2012. We replaced logic board and IO board, but it still won’t turn on. The magsafe charger light is orange, and does’t turn green after the usual time to charge. I tried resetting MMC without change. There is no noise, no light with pressing the “on” button. Nothing else is obviously damaged inside. Update MBA-2012-13in-LB.pdf Attached is a photo of the logic board....