Posts

Chosen Solution I am trying to get the a.m. stations on my g.e. radio and they come in for a few seconds and then they are gone Update (10/16/2016) 3-5624a is the model number @kjoann86 transitor radios started using an internal antenna for the AM signal. FM signal is captured through the external one, that in your case has the broken tip. For some stations and locations the internal antenna just is not strong enough to receive a good signal....

Chosen Solution Even after using my Roomba to vacuum my carpet, there is still a lot of pet hair and dirt. What’s wrong with my Roomba? The Roomba’s brushes could be clogged. Check out this Troubleshooting Page to get tips on how to clean the brushes. If the brush is not clogged, the problem could be caused by a mechanical error and the brush may need repair. What’s your Roomba model?...

Chosen Solution A month ago my computer started to sound very noisy, i don’t know whats happening but it sounds like something stuck in my fan. I opened it and try to see if there was something but is not. If somebody know’s what could be, tell me; because it’s sounds terrible! Fans do fail. If it’s a screeching sound I would replace it. Here’s the part: MacBook Pro 13" Unibody and MacBook 13" Unibody Fan If nothing else remove it and shake it out....

Chosen Solution why my phone is not turning on? Here are one of many reasons: Battery too low Bad charger port Software corrupt Nand Memory chip corrupt Water damage Bad Battery Do you get any response from the phone at all?

Chosen Solution I have a 2009 Maytag Bravos Quiet Series 300 washing machine – model number MVWB700VQ0. We just moved to a new house, and as far as I know it was working fine in the old house. Now, the cycle starts and water sprays in the machine, then the water runs through the detergent cup. The machine spins to balance the load, and when the tub slows to fill, nothing happens....

Chosen Solution I fully charged my DigiLand DL1010Q but the batter only lasts for a short amount of time. My device used to hold charge for hours upon hours, and now it only lasts an hour, if that. If the battery will not hold charge, generally this means the batter is no good. Don’t worry though, this is an easy fix. For more information go to the DigiLand DL1010Q Troubleshooting Page!...

Chosen Solution My laptop was working last night, but when I tried to start it this morning nothing happened. Here is the link to the troubleshooting page for the HP Pavilion g7. Be sure to check if the battery is uncharged before opening the laptop. Hi John, have you solved your HP Pavilion G7 problem? It seems i’ve got the same problem. I bought a new adapter but the problem remained....

Chosen Solution Will I lose True Tone if I replaced the Front Camera and Sensor Cable? iFixit Guide: iPhone 8 Plus Front Camera and Sensor Cable Replacement No, You will lose True tone if you Change the Screen. I have lost………

Chosen Solution My phone once connected to wireless networks..no more.Can I fix it myself…Steve Why yes I did drop my phone,good point.I’am connected to AT&T and I recently downloaded “weather radar and yelp.The wireless network is WiFi.Thanks for the attention.. What happened between you being able to connect to wireless networks and not being able to connect to them? Did you drop your phone? Did you install a new software? Are you still paying the telecom company to use their service?...

Chosen Solution My visor will not stay up completely. It flops / hangs down which hinders my full vision when driving. Hi @bjteacher Unfortunately you may be too late to get the visor replaced by Toyota under their recall plan for the defect. According to this link it will only be replaced by them, during a 7 year period from the date of first use, which by now has probably elapsed....

Chosen Solution Hello, I have a UE Boom (first version), it was working fine and no delay whatsoever, but after the last update (10.0.10) I got the sound delay problem, like the sound is delayed 1.5 seconds from the connected device. Does anyone have the same problem ? Or can I downgrade by any chance? Email addresses of those in charge at Ultimate Ears/Logitech (THESE ARE THE PEOPLE TO COMPLAIN TO BY EMAIL): fmarteau@logitech....

Chosen Solution Steamer only steams hot for a few moments and then just air don@profitnessclubs.com This machine doesn’t pump while in steam mode, which means all the steam you get is what was converted from the water that was already in the boiler. I would run hot water through the steam wand to make sure the boiler is as full as possible, then switch over to steam mode, making sure to wait until the machine indicates it’s at steam temperature before opening the steam knob....

Chosen Solution I have a Microsoft Surface Pro 3 Docking cradle that has a loose connection on the riser that has the connector that connects to the Surface Pro 3 itself. If it is physically manipulated it can be made to work until its bumped again. I am looking for a teardown guide so I can disassemble and repair this myself. Hi, I have a smilar problem. I am certain it is probably a loose connection....

Chosen Solution Hello everyone! Here is my case, hope you can help me or throw me any advice: I have an iMac 21.5 mid-2011 Core i5 with the video card failing, It freezes and then shuts down. On the other hand, there’s an iMac 21.5 Core i3 mid-2010 with a damaged logic board. Is it possible to install the mid-2010 graphics card into the mid 2011? or any other chance to mix & match and get one good working Mac?...

Chosen Solution So, for the past three days I’ve had this problem with my phone. It started Monday, when I’d woke up to watch a bit of YouTube and my hone just went black. I was worried so I contacted Apple Support. I followed their instructions and nothing prevailed. Being the frugal person I am, I decided to wait out the day to see if eventually my phone would work. After leaving it on the charger for maybe three hours my phone’s screen had become back visible and was on the recovery mode screen....

Chosen Solution My display looked perfect, but the power button was malfunctioning and the battery life was poor. I carefully followed the iFixit guides after buying the parts here. I replaced the battery, flex cable, installed new speaker meshes, installed the display, and when I turned it back on, it looked like this. The screen is not broken in anyway, but I did use 70% isopropyl to clean the glue from the edge of the display....

Chosen Solution My reverse lights havent worked since i changed steering columns. So that i had tilt the other day i plugged in a trailer and they suddenly started working since i dont know where their activated from its hard to track down the problem Trikkidick West, since the reverse lights went out after changing column probable bad wire/plug connection at the park,neutral,reverse bulb switch which is attached to lower part of steering column....

Chosen Solution Having some issues with a grey vertical line intermittently on the screen. When I touch around the actual screen it seems to make the problem occur more. When I leave it upright and open on a flat surface sometimes it will go away. Sadly you banged your systems lid or stat something heavy on it damaging the LCD panels connections to the ribbon cable. We call this failure a TAB error....

Chosen Solution Washer continues to put water in the washer but never fills it enough to start washing because it is slowly draining as well. How do i fix this? It’s draing and filling at the same time. How far down the drain pipe is your drain hose? It needs an air-break in the drain hose 36" above the floor or it will create a siphon. I usually use a few zip ties to secure the drain hose so the end of hose is 36" inches from floor, and make sure the end of hose is secure in the drain pipe or it could pop out during use....

Chosen Solution so I was eating cereal and I guess a drop of milk got on the speaker and now it doesn’t work anymore More than likely the milk may have dried and is blocking the gold contacts on your ear speaker to the front camera flex. If you are comfortable opening your phone, then some alcohol and a soft brush would probably do the trick after removing the front camera flex and ear speaker....