Posts

Chosen Solution hi guys, my mrs has a zg5 notebook and on sunday she noticed that the notebook wouldnt charge unless the charger was fiddled with and in a wierd position, the following day it wont turn on and it wont charge. not do any lights come on when the charger is plugged in, the orange light flashes 3 times when i hit the power button but thats it. Im not sure if its the charger cable, the port where the charger slots into on the netbook or something else....

Chosen Solution I have new batteries in my TI-83 it is just there is some lines of dead pixels going up to down how do I fix it Likely a bad flat flex cable,. This fellow shows how to fix that here

Chosen Solution So I have this Loewe Speaker 2GO which didn’t make a BT connection anymore, not long after, it didn’t give power at all. I measured the batteries and found out they don’t give power anymore. I was wondering, can I replace the old Li-Po batteries with any other Li-Po or Li-Ion battery with the same mAh? Thanks in advance! I haven’t opened it yet but if you remove the long plastic cover on the front/bottom you can unscrew the unit....

Chosen Solution I bought a speak for my boyfriend birthday not even a year later the speaker end up not working. It plays music but if you turn the volume up higher it will just stop and turn off completely. If you charge it I won’t even stay charged what is wrong with my speaker please help. Resetting the JBL Flip 2 can be accomplished by holding the “power” and “lower volume” buttons until the light turns red....

Chosen Solution Why does it display Headphones on screen when I try to adjust volume and no sound comes from speaker? Get a pin or something like that and give the headphone jack a good clean out. They gather fluff up there and it could be causing the problem. If that doesn’t work then it would need replacing. Not a massive job so it should be a cheap repair at a local shop if you aren’t confident enough to do it....

Chosen Solution My 10.5” iPad Pro 2 (2017) Model MPDY2CLA/A has the white spot issue a few centimeters above the home button. Recently the screen has started to dim a bit sometimes when moved or gripped and then last night it started with a “Stagelight’ effect across the bottom of the screen above the home button - like the Macbooks did. Any easy fix or resolutions for this? My guess is it’s related to the white spot pressure point?...

Chosen Solution Hey guys! I’ve been having bad upwards stickdrift on my right stick, so I took it apart and adjusted it to nearly completely remove it. It was fine. A bit of tiny downwards drift, but barely noticeable. Not long after, the drift has returned. I going to have to rip it apart and asjust sever times a day, or am I just doing it wrong? You can try cleaning the stick with 99....

Chosen Solution how can i fix my broken screen I’ve been searching for a replacement as well but haven’t broken it yet I kinda want to upgrade my SSD but also a bit paranoid about the screen so I went searching for one I found one place that sells a replacement but it isn’t cheap you may as well buy a new one for that price… Surafe Pro 3 LCD-Pannel- Digitizer Assmebly-$500....

Chosen Solution Swam (in shallow/neck deep freshwater stream,) with Fitbit versa 2, it was on, for 10 minutes during swim. Then, at 12 or 13 minutes went black. I, also, have several units that have the screen popped off. …and quit, as well. hi @natureokie The Fitbit Versa 2 should be waterproof to a depth of 50 metres. How long have you had the device? According to the warranty there is a 1 year (or 2 year depending on your location) warranty on it....

Chosen Solution My MacBook Pro 2011 won’t boot due to a short circuit (sparks) with my screwdriver. Fans and Chim don’t work but the HD is spinning. The USB ports are working also the DVD drive and thunderbolt. External monitor gives no response. Powerbutton is working and batt is charging. Does anyone have a suggestions to fix this. Thanks Winn Well that’s bad … You’ll need to find someone to fix your logic board that might be hard....

Chosen Solution My KitchenAide Elite stand mixer will not stay off when the dial is at 0. It will stop for only about 1 minute and then go at almost full speed. The only way to keep it off is to keep it unplugged. Most likely is a shorted circuit board. Test with a multimeter: KitchenAid Classic Mixer K45SSWH Circuit Board Replacement

Chosen Solution My Sony ICFC1 alarm clock has been continuously flashing between the time and “OFF” on the display. Also, the buttons on the back to set time do not correspond with one another. why would my clock flash this way, also flashes cycle of date as if setting time and has been keeping incorrect time. Hi, Try a power reset and see if this resolves the problem. Turn off the AC power to the clock....

Chosen Solution A few months ago my xbox would shut down after about 40 minutes of gameplay and the light in the center would turn red making the only way to turn it off completely be by plugging it off the wall. Now when I try turning it on, the light on the power brick goes from orange to green for a split second and the xbox’s light from green to red as well....

Chosen Solution My f717 is fully functional in every respect when taking a picture. But when the “review” of a photo is viewed in either the viewfinder or lcd display its shrinks to a useless miniscule size. I cant zoom into to it either. The same thing happens in “play” mode. So i cant see if my pictures are useable untill i upload to a computer. Have i done something to the software like deleted/edited something by accident....

Chosen Solution Hello! When I was trying to delete the history on my calculator, I must have done something wrong and now, slowly but surely, the screen is disappearing. Please refer to the picture posted and help me solve this problem. The cable that connects the display to the board has failed. Unlike the color versions of the TI-84, the display is held onto the calculator with a TAB (Tape automated bonding) connection that cannot be removed non-destructively....

Chosen Solution I had someone replaced my dead LCD with a new one but it seems that the LCD was installed without even cleaning up the dust particles left on the back of the screen so the dust spread on the receptors/backlit sheets. I decided to open the screen by removing the bezel carefully. The LCD was not quite hard to remove as it was not completely holding the adhesive around it so it was easily detached....

Chosen Solution When trying to take a picture the flash does not fire in low lighting. Make sure you are in the correct shooting mode. Placing the camera in silent mode or continuous mode will prevent the flash from operating. Additionally, low battery power will result in the flash not operating to save power.

Chosen Solution I recently bought a replacement battery (from ifixit) for a 6th gen iPod touch and I replaced the battery without much hassle (other than I broken screen but that was much easier to replace). I did all the soldering of the battery by myself and the joints looked good. When I put the screen back on and turned on the iPod, it seemed to work fine so I just let it sit for a while and waste charge so I could calibrate the battery....

Chosen Solution My iPhone 6s screen won’t work after I have replaced it with a replacement as it’s completely unresponsive and there’s a black bar at the top of the screen. extra info: the speakers, vibrations and all buttons work. any help will be much appreciated looks like touch ic failure, its got the same symtoms like the black line at the top

Chosen Solution i droped the camera and now the lense does not move out to take photos You dropped the camera causing the lens to jump or deform the guides that move the lens. If under warranty see if it can be replaced… if not see if its worth fixing. Generally these sorts of things are not DIY repairs If this answer was helpful please remember to mark it accepted. Good Luck, N...