Posts

Chosen Solution I put my gopro hero+’s touch display off and the screen went off and cant seemntobget it on again! Have to use the small screen in the front now but it does not give me option to put touch display back on! Please help! Hi, Here is an image taken from the Gopro Hero + LCD user guide which shows that if you navigate with the Power/Mode button to the Set Up mode icon, you should be able to access the Touch Display icon, select it and then presumably turn it on or off....

Chosen Solution the machae does not drain Cause 1 Drain Pump Sometimes, small objects or articles of clothing can get caught in the drain pump. To determine if anything is blocking the drain pump, remove the drain pump and check the pump for obstructions. If the drain pump is clear of obstructions, but is still noisy during the drain cycle, replace the drain pump. Cause 2 Clogged Pump or Hose Sometimes, socks and other small articles of clothing can get into the drain system and clog the pump hose or the pump itself....

Chosen Solution I have two X360s that I’m trying to repair. The first one I fixed by replacing the worm drive motor, then I got this other one I’m trying to fix. Then the first one I repaired came back with the same problem again about a week later. Both experienced the same problem of moving the laser beyond the rim of the disc (after several attempts to open and close the disc tray when the systems said “open tray” or loaded the disc incorrectly), and not returning to the spindle....

Chosen Solution I’ve recently replaced my optical drive, following all steps from this guide, and opening up the old and new drives to switch the PCBs. Upon installing the new optical drive with the old PCB soldered and connected up, I tried to turn my Xbox One on, but it won’t turn on. When pressing the front panel buttons, there will be noise from the speaker, but it’s much more quiet than usual, but that does mean that there is power....

Chosen Solution If I were to copy the iCloud locked motherboard’s serial number to a new motherboard with something similar to an QianLi iCopy, would the IC Locked motherboard transfer the IC lock to the new motherboard? Or would the phone be unlocked? Thanks No you cannot copy the SN to another phone. This is a security feature stopping people accessing your data from a stolen phone.

Chosen Solution Won’t turn on even when the MagSafe is plugged in. This is a new MagSafe that had been working. Laptop just stopped working. Is this a hardware issue that could be repaired? Update (06/08/2017) It is a ME864LL/A 128GB. I am not aware of any water and or drop damage. I have the back off and do not see any obvious signs. The MagSafe MD565LL/A was from the Online Apple Store and was bought 8/16....

Chosen Solution I don’t know if the TI-84 Plus calculator was dropped, but the screen is 2/3 stripes, therefore the calculator cannot be used. I tried replacing the batteries and a reset. Hi, perhaps the ribbon cable connecting the motherboard is partially loose. Just to be sure, I’d like you to run a self test Turn the calculator on and put it on the home screenPress [mode]Press [Alpha]Press [S] (the ln key)Press [enter] four times (congratulations, you’re now in the diagnostics section!...

Chosen Solution Have a 6 with no sound. Have tried the following: -Replaced speaker -Replaced dock connector -Restore to factory settings Anyone else have similar problems? Thanks James If there is no sound through earpiece, and headphones, then the audio IC may be faulty, but since you are only experiencing problems with speaker, I would try cleaning the speaker contacts with alcohol. Did you manage to fix this issue? I am having the exact same issue

Chosen Solution For awhile now my printer has been printing spots about every 7 centimetres. I have cleaned the drum roller a few times and every time it seems to add a new spot. Eventually I bought a replacement drum unit and this has fixed the problem. BUT I want to know what caused the problem as the drum has always looked clean. My conclusion is that the problem is on the drum because the diameter of the drum matches the distance of the spots....

Chosen Solution Hi. First I sorry for my bad english I have TIME CAPSULE 1TB A1355 from second hand and i have some problem with it. When i plug in to power time capsule have a green light for the one second, afer that light change to orange. Nothing more happens. Device doesnt sent any wifi signal, my laptop doesnt see it. I try do connect by RJ cabel but Airport Utility see only wirless signal....

Chosen Solution knob turns gear only to settings 3 and 4. From these settings knob turns but does not change setting. How do I replace gear. Hi, check out the instruction manual to confirm you are selecting the stitches correctly - before you try any repair: https://www.manualslib.com/manual/869926…

Chosen Solution I turn camera on and get this message, lense doesn’t open. This is usually because the lens area has been contaminated by dust, sand, etc. The extension of the lens has either been stopped or stuck on a grain of dirt. The damage can be sometimes be repaired by cleaning the camera lens area. However, if the motor that controls the zoom extension has had to work hard enough, it may have melted one or both of the lines to the motor....

Chosen Solution I’ve had the system for over two months. I dropped the system once, and shortly after there was no volume to be heard. Nintendo couldn’t repair it either. The first thing to try is a reset. its the least expensive, or invasive repair. Follow the guide for factory resetting your DS. If nintendo tried repairing it, this would have been the first thing they do. a couple problems can cause the issue....

Chosen Solution My phone has been overheating, and I don’t know if I’m just overusing my phone or if I have a hardware problem. Any suggestions would be greatly appreciated. It might be commonly overheating because you have many apps or programs open and running in the background without fully closing them when you aren’t using them. This is just the most common and probable cause but for more information go here...

Chosen Solution I have been given a Wallstreet G3 Laptop, which boots up fine, however when the desktop appears on the screen the mac instantly goes to sleep and wont wake up, I have tried the obvious, ie rebooting with extentions off. Any idea why it keeps doing this? Here is the link to the teardown–I will post a parts link shortly. Ralph PowerBook G3 Wallstreet Repair Here’s the link for the part....

Chosen Solution Hi Good day, I have extremely new to microsoldering. I have a hakko fm 203 with a Hakko, T15-BC1, Soldering Tip, Bevel, 1mm x 11.5mm to solder. I am practicing removing BGA chips, tinning the pads and applying the Chips back on, however, a major issue I seem to be having a getting rounded solder balls. I am not sure if Its the way I am holding the soldering iron or if it I using the wrong tip entirely (I do use flux when attemping this but my pads seem to look horrible)....

Chosen Solution My Ipad suddenly show battery is 1% and keeps restart , and when i shut it off and keep it recharging , it reaches 100% but also keeps restarting, restred the last updated firmware with no help, is the battery needs replacing ? The most likely scenario is a bad battery. The iPad Air’s are getting old and it’ normal for these batteries to be dying off. You can follow this guide for the replacement....

Chosen Solution Why is my cosmo robot turning off out of nowhere? I had exactly the same issue with my Cozmo. It was shutting off after 2-3-5 minutes of use with no warnings and no matter how long it was sitting on charger. I was blaming myself since my Cozmo fell off the table. I fixed the issue by re-welding contacts for the battery. Even if it looks well connected, you might give it a try....

Chosen Solution I replaced the home button with a new button as well as gasket and at first when the home button wasnt clicking I thought it was cause it had no gasket but now that it does it still feels squishy and the only other thing I can think of is that the screw on the top right of the home button bracket is missing but the button still has 2 screws in I even tried bending the bracket in some but it still would not click, Help please :(...

Chosen Solution When I press the power button the lights come on but the screen is black. I heard the ventilator is working. The keyboard has a backlight but nothing is to be seen on the display. Any ideas? Hi, Connect an external monitor and see if there is a display on it with the laptop turned on. If there is no display on the external monitor either then you have either a GPU or motherboard problem....